SF-IP382CA-4I1-SOLAR4G Configuration

Once the camera is turned on, it can be detected with the IP Manager Tool software to activate it and set an IP address:

• IP Manager Tool

Once this is done, the camera can be accessed with the browser and configured.

Configuring the APN for communication via the SIM card

In the Network section you can access all network parameters, where one of the most interesting for this camera is the APN configuration:

Dialing State - Information on the status of the data connection

Dialing Parameters - SIM card data settings (APN, username and password)

Power Consumption Modes

• Full Power Mode

In this mode the camera remains active.

• Low Power Mode

This mode keeps the 4G network, PIR (passive infrared) detection and event recording active. The camera goes to sleep when it does not detect motion, which helps to conserve power

Note: In low power mode, parameters such as the frequency of the audible alarm and the frequency of the flashing alarm may change.

• Manual Sleep

In Manual Sleep, you can set a schedule for when the camera should go to sleep mode.

Alarm

Motion Detection Configures the motion detection area, sensitivity, activation mode and schedule Exception Alarm Configure the relevant parameters of the abnormal alarm, as well as the linkage after several abnormal alarms. Alarm Server Configuration and settings of the alarm server Audio Alarm Configure the relevant information about the audio alarm. Light Alarm Configure the relevant information about the light alarm. PIR Alarm Configure the PIR information. Event

Object Abandoned/Missing Intelligent detection of abandoned or missing items. Video Exception Image distortion correction. Line Crossing Intelligent analysis of line crossings Region Intrusion Intelligent Region Intrusion Detection

Scheduled screenshots

The Time lapse function, which saves screenshots every X seconds, is performed as follows:

1. Snapshot Parameters

2. Event Trigger

3. Timing Snapshot