Arm and Disarm (Video Alarm Tablet)
This article describes how to arm and disarm your Solink alarm system via the Solink Video Alarm Tablet. Click here for a guide on how to arm and disarm via the Solink platform.
Enter the correct 4-digit PIN number on the Solink Video Alarm tablet to arm or disarm the alarm system.
Arming the Tablet
When you arm the Video Alarm Tablet, you have 30 seconds by default to leave the premises/camera view before the system fully arms:
You can configure the amount of time provided to leave the premises after arming, in seconds, under the Arm / Disarm Countdown (sec) field in the "Set up with Tablet" section:
Disarming the Tablet
When entering the premises to disarm the system, you are granted the same amount of time (the time defined by the Arm / Disarm Countdown field) to disarm before an alarm is triggered.
A countdown sound plays once the system detects motion on any alarm camera.
You must enter the correct PIN during this time or else an alarm is triggered:
If you fail to disarm the system before the grace period expires, as shown in the image above:
An alarm is triggered in Solink.
The "Active Alarm" icon flashes on the screen, as shown in the image below.
An alarm sound (beeping) emits from the tablet speakers.
Note: After arming or disarming, the amount of time the alarm system remains in that state is dependent on the hours you have configured in your alarm schedule (unless you arm/disarm the system indefinitely).
Was this article helpful?
Bu bilgiler sorununuzu çözmeye yardımcı oldu mu?
Still need help?
Uzman ekibimiz size yardımcı olmak için burada.